![]() I want to switch VOLUME CONTROLS from to control my TV or to my Audio Device.įollow ASSIGNING VOLUME CONTROLS instructions in this document INPUT key blinks, but remote does not control my equipment.įollow the programing process in this manual to set your remote up to control your home theater equipment. VOLCable Box Icon = To lock volume controls to the cable box, Press MUTE.Audio Icon = To lock volume controls to the audio device, Press.TV Icon = To lock volume controls to the TV, Press VOL +.Press the key below for the device that you wish to use for volume controls:.If you wish to change volume control settings from these defaults, perform the following steps: If the remote is also set up to control an audio device, then volume controls will default to that audio device. The remote is set to default to control TV volume once the remote is programmed for a TV. If not, repeat this process using the next code listed for your brand. If the device responds as expected, setup is complete. The INPUT KEY will blink twice to confirm once complete. Enter the 1st code listed for your brand.Show remote with MENU and OK keys highlighted Simultaneously press and hold MENU and OK keys on remote until the INPUT key blinks twice.Ensure that your TV and/or audio device is powered on.For faster setup, be sure to locate your device brand in the code list before beginning setup. This step covers setup for all TV and Audio brands. NOTES: While holding the digit key, the remote will test for the working IR code, causing the INPUT key to flash each time it tests a new code. Show remote pointed at TV, transmitting data and TV is off Release the digit key when the TV turns off. ![]() Find your TV brand in the chart below and note the digit that relates to your TV brand.If your brand is not listed, please proceed to SETUP USING DIRECT CODE ENTRY ![]() This step covers setup for the most common TV brands. Programming Your Remote for TV and Audio Control Press and hold MENU and the 3 digit key simultaneously until the INPUT key blinks twice.If your cable box is branded Cisco, Scientific Atlanta, or Samsung:.Show remote with MENU and 3 keys highlighted Press and hold MENU and the 2 digit key simultaneously until the INPUT key blinks twice.If your cable box is branded Motorola, Arris, or Pace:.If the cable box responds, skip this step and proceed to PROGAMMING YOUR REMOTE FOR TV AND AUDIO CONTROL. Point your remote at your cable box and press MENU to test. If you have a WorldBox, refer to the section above for remote pairing, following the on-screen instructions for any other remote programming. This section is for any cable box that is NOT a Charter WorldBox. Programming Your Remote for Any Other Cable Box Show remote digits with 9-8-7 highlighted in order. The INPUT key will blink four times to confirm pairing has been disabled. Show remote with MENU and Nav Down keys highlighted Press and hold MENU and Nav Down keys simultaneously until the INPUT key blinks twice.If you wish to use the remote with a different cable box, follow these steps to un-pair it with your WorldBox. Follow the on-screen instructions to program the remote control for your TV and/or audio equipment as needed. A confirmation message should appear on the TV screen.Show image of remote pointed at the TV, transmitting data The Input key will begin blinking repeatedly. To pair the remote, simply point the remote at the WorldBox and press the OK key.Show image of STB and TV connected and on Ensure that your TV and WorldBox are both powered on and that you can view the video feed from the WorldBox on your TV.If you do NOT have a WorldBox, proceed to PROGRAMMING YOUR REMOTE FOR ANY OTHER CABLE BOX. If you have a Charter WorldBox, the remote must be paired with the box. ![]() Show bottom of remote with battery door in place, include arrow for slide direction.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |